Thay công tắc đèn pha ab 2014

brownmeercat133

New member
Honda Civic ** Cách thay thế công tắc đèn pha AB trên chiếc Honda Civic 2014 **

Công tắc đèn pha trên Honda Civic 2014 là một thành phần đơn giản có thể dễ dàng thay thế tại nhà.Hướng dẫn này sẽ hướng dẫn bạn qua quá trình, từng bước.

** Những gì bạn sẽ cần: **

* Công tắc đèn pha thay thế
* Tua vít đầu Phillips
* Torx T20
* Công cụ nêm
* Băng điện

**Hướng dẫn:**

1. ** Xác định vị trí công tắc đèn pha. ** Công tắc đèn pha được đặt ở phía bên trái của cột lái, ngay bên dưới tay lái.
2. ** Tháo bảng điều khiển trang trí. ** Sử dụng tuốc nơ vít đầu Phillips để tháo hai ốc vít bảo vệ bảng cắt lên cột lái.Khi các ốc vít được gỡ bỏ, cẩn thận tìm ra bảng điều khiển ra khỏi cột lái.
3. ** Ngắt kết nối dây nối. ** Có hai đầu nối ở mặt sau của công tắc đèn pha.Sử dụng tuốc nơ vít Torx T20 để ngắt kết nối các đầu nối.
4. ** Tháo công tắc đèn pha. ** Có một vít duy nhất bảo vệ công tắc đèn pha đến cột lái.Sử dụng tuốc nơ vít đầu Phillips để tháo vít.Sau khi tháo vít, công tắc đèn pha có thể được kéo ra khỏi cột lái.
5. ** Cài đặt công tắc đèn pha mới. ** Chèn công tắc đèn pha mới vào cột lái.Đảm bảo rằng công tắc được căn chỉnh đúng với các khe trong cột lái.Đảm bảo công tắc đèn pha bằng vít đầu Phillips.
6. ** Kết nối lại dây nối. ** Kết nối lại hai đầu nối ở mặt sau của công tắc đèn pha.
7. ** Thay thế bảng điều khiển trang trí. ** Nhấn cẩn thận bảng điều khiển trở lại vị trí.Đảm bảo bảng điều khiển bằng hai ốc vít.

** Kiểm tra công tắc đèn pha. ** Bật công tắc đánh lửa sang vị trí "BẬT".Đèn pha nên bật.Chuyển công tắc đánh lửa sang vị trí "TẮT".Đèn pha nên tắt.

**Lời khuyên:**

* Cẩn thận không làm hỏng dây nối khi ngắt kết nối các đầu nối.
* Sử dụng một miếng đệm mới khi cài đặt lại công tắc đèn pha.
* Nếu bạn gặp khó khăn trong việc tháo công tắc đèn pha, bạn có thể thử sử dụng súng nhiệt để nới lỏng chất kết dính.

** Hashtags: **

* #2014Hondacivic
* #headlightswitch
* #tự làm lấy
* #sữa chữa ô tô
* #bảo TRÌ
=======================================
Honda Civic **How to Replace the AB Headlight Switch on a 2014 Honda Civic**

The headlight switch on a 2014 Honda Civic is a simple component that can be easily replaced at home. This guide will walk you through the process, step-by-step.

**What you will need:**

* Replacement headlight switch
* Phillips head screwdriver
* Torx T20 screwdriver
* Wedge tool
* Electrical tape

**Instructions:**

1. **Locate the headlight switch.** The headlight switch is located on the left side of the steering column, just below the steering wheel.
2. **Remove the trim panel.** Use a Phillips head screwdriver to remove the two screws that secure the trim panel to the steering column. Once the screws are removed, carefully pry the trim panel away from the steering column.
3. **Disconnect the wiring harness.** There are two connectors on the back of the headlight switch. Use a Torx T20 screwdriver to disconnect the connectors.
4. **Remove the headlight switch.** There is a single screw that secures the headlight switch to the steering column. Use a Phillips head screwdriver to remove the screw. Once the screw is removed, the headlight switch can be pulled out of the steering column.
5. **Install the new headlight switch.** Insert the new headlight switch into the steering column. Make sure that the switch is properly aligned with the slots in the steering column. Secure the headlight switch with the Phillips head screw.
6. **Reconnect the wiring harness.** Reconnect the two connectors on the back of the headlight switch.
7. **Replace the trim panel.** Carefully press the trim panel back into place. Secure the trim panel with the two screws.

**Test the headlight switch.** Turn the ignition switch to the "ON" position. The headlights should turn on. Turn the ignition switch to the "OFF" position. The headlights should turn off.

**Tips:**

* Be careful not to damage the wiring harness when disconnecting the connectors.
* Use a new gasket when reinstalling the headlight switch.
* If you are having trouble removing the headlight switch, you can try using a heat gun to loosen the adhesive.

**Hashtags:**

* #2014Hondacivic
* #headlightswitch
* #diy
* #AutorePair
* #maintenance
 
Join ToolsKiemTrieuDoGroup
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock